Conductor Command problem in Multiple sequential routes

    Hello



    I hope that everyone is staying healthy!


    I have a problem with the Conductor command in multiple sequential routes operating at the same time.



    I have 2 sequential routes:


    Route #1: this route has 4 sequential routes, the first route is set to ‘Semi Auto’ and the following three routes are “manual” and controlled by conductor commands in each card7.


    Route #2: this route has 3 sequential routes, the first route is set to ‘Semi auto’ and the following two routes are “manual” and controlled by conductor commands in each card 7.


    If I operate either of these two routes (#1 and #2) separately, they function OK.


    However, if I allow them to operate at the same time, Route #2 always fails at the Conductor command between the 2nd and third route in the sequence. The 3 rd route does not activate.


    Do you have a suggestion?




    Best Regards,


    Don