48723 0 Wall plate clinker brick of Stone Art, weathered, L 53,5 x W 16 cm

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

Weight for CarMotion MB Actros vehicles with M cab. Retrofitting ahead of the front axle. The weight increases the front axle’s downforce on the road, enabling the maneuvering of trailers through tighter radii.

These couplers allow you to provide an easy power supply system for the entire train. The couplers are equipped completely with 2 connection cables and fit into the standard NEM 362 coupling shaft. The couplers are contact-proof and cannot be uncoupled automatically, yet easy to separate and to couple. The thin cables (0.6 mm) allow a very easy mounting. Current consumption: max. 750 mA.Contents: 3 pairs with 3 adapters each (S: norm, M: +0.3 mm and L: +0.6 mm).

With beam. Filigree metal work with stamped rivet imitations. Mast height: 11,5 cm.

12 light boxes - each 3 pieces in 4 different sizes and one house lighting LED white. The light boxes provide completely new clear lighting of each single room. For lighting we recommend our LEDs with connection cable in yellow item 6047, white item 6048 and warm-white item 6046, the boards with an LED in yellow item 6007, white item 6008, warm-white item 6006, boards with two LEDs in yellow item 6018, white item 6017 and warm-white item 6021 or the LED with TV simulation item 5079. Light boxes should be fixed inside the house behind the windows. Light is prevented from shining through. Also suitable for TT and N buildings. Dimensions light boxes: L 1,7 x W 1,8 x H 2,6 cm, L 1,7 x W 1,6 x H 2,1 cm, L 1,7 x W 1,2 x H 1,9 cm, L 1,7 x W 1,4 x H 2,3 cm.

Especially for a safe connection and current transmission.