3550 LED red Ø 3 mm, incl. resistors, 4 pieces

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

available

The self adhesive magnetic tape is polarized on its surface (south pole on top). It leads the guiding magnets of the CarMotion vehicles. Depending on the type of road, it is integrated into a prefabricated road system or built into the layout plate with the help of a surface milling machine. Dimensions: L 500 x W 0.3 x H 0.1 cm.

available

This basic wall lamp is ideal for storage buildings, sheds and depots for the epoch III. Maintenance free by LED lighting.

available

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

available

Prototypical brass mast with base socket for easy mounting. Maintenance free by LED lighting. Height: 9 cm. Suitable for kibri stations, e. g. item 39507, 49517 or 39491, or Vollmer stations, e. g. item 43501, 43510, 43512 or 43524.

available

These couplers base on the Fleischmann Profi plug-in coupling 6515 and provide power transmission up to 1 A each contact. They are also vertically self-centering, which effectively prevents unintended uncoupling (e. g. at the transition from horizontal track to a gradient). Uncoupling – even delayed uncoupling – is possible. This allows you to provide an easy power supply system for the entire train. As a result, pick-ups are not required for all coaches. This in turn reduces the load to be drawn by the locomotive. The couplers are equipped completely with 2 connection cables and fit into the standard NEM 362-coupling shaft. The thin cables (0,6 mm) allow a very easy mounting.

available