12066 Collector display with track L 33.0 x W 6.0 x H 6.5 cm

Without vehicle. L 24.5 x W 6.0 x H 6.5 cm

currently not available

4 switches providing comfortable switching of lights, signals and other elements using continuous current. It can also be used as a set of two double pole switches, with the use of the included couplings. Contact load: 2 A.

available

Kit. L 280.0 x W 0.2 x H 2.5 cmLevel of difficulty: 1 (beginners)

currently not available

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

available

Ideal item to use with our light boxes of house lighting starter set, item 6005 to illuminate each single room or with light rails, item 6045 for floor interior lighting. One LED each, fastened to a small board, provides suitable brightness.

available

This special point machine is a powerful, silent drive with its respective digital decoder for installation in Märklin and Trix C road bed points. The decoder is located in the cable making the drive particularly compact. The point machine stands out for the prototypical slow movement of the point blades. Speed and motion are controlled electronically and ensure a sensitive drive. If – due to the characteristics of your turnout – the direction of the turnout does not fit with the switching direction of the command station, it is possible to set the point motor to reverse mode. The associated decoder is suitable for DC/AC, MM and DCC and is able to send the requested position or the actual position by RailCom to corresponding digital command stations (e. g. Viessmann Commander item 5300/5320). Analogue mode is possible. Additional switching outputs for relays or LEDs and for a conventional feedback and frog polarisation complete the functions of the point machine. Their function is configurable.Märklin C turnouts:24611 left hand turnout24612 right hand turnout24624 double slip switch DKW24630 three way turnout (2.pieces drives)20671 left curved turnout with manual hand lever20672 right curved turnout with manual hand lever24671 left curved turnout24672 right curved turnout24711 left hand wide radius turnout24712 right hand wide radius turnout24771 curved turnout left24772 curved turnout rightTrix C turnouts:62611 C track left hand turnout62612 C track right hand turnout62624 C track double slip switch 62671 C track left curved turnout62672 C track right curved turnout62711 left hand wide radius turnout62712 right hand wide radius turnout62771 curved turnout left62772 curved turnout right

currently not available