5273 Mini-LED red-yellow for fire simulation, 3 pieces with micro-blinker electronics

12 light boxes - each 3 pieces in 4 different sizes and one house lighting LED white. The light boxes provide completely new clear lighting of each single room. For lighting we recommend our LEDs with connection cable in yellow item 6047, white item 6048 and warm-white item 6046, the boards with an LED in yellow item 6007, white item 6008, warm-white item 6006, boards with two LEDs in yellow item 6018, white item 6017 and warm-white item 6021 or the LED with TV simulation item 5079. Light boxes should be fixed inside the house behind the windows. Light is prevented from shining through. Also suitable for TT and N buildings. Dimensions light boxes: L 1,7 x W 1,8 x H 2,6 cm, L 1,7 x W 1,6 x H 2,1 cm, L 1,7 x W 1,2 x H 1,9 cm, L 1,7 x W 1,4 x H 2,3 cm.

available

Ideal for use with the floor interior lighting item 6045. The LEDs can be precisely glued into the racks for individual illuminating of entire floors or individual single windows in buildings of all kinds. Each one LED provides the right brightness. Also available as item 6047 yellow and item 6048 white LED. Same for light boxes of house illumination starter set item 6005.

available

These couplers allow you to provide an easy power supply system for the entire train. The couplers are equipped completely with 2 connection cables and fit into the standard NEM 362 coupling shaft. The couplers are contact-proof and cannot be uncoupled automatically, yet easy to separate and to couple. The thin cables (0.6 mm) allow a very easy mounting. Current consumption: max. 750 mA.Contents: 3 pairs with 3 adapters each (S: norm, M: +0.3 mm and L: +0.6 mm).

available

The transformer provides model train accessories, e. g. lamps, signals and turnouts with required low voltage. Suitable for all kinds of model train systems. Integrated overload protection avoids overload and short-circuit breakdown by timeous cut-off of the transformer. Technical data: Input voltage 230 V - output voltage 10 and 16 V~, maximum power 52 VA. Dimensions: L 13 x W 7 x H 5 cm.

available

Especially for a safe connection and current transmission.

available

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

available