5566 Sound module Lovers

This turnout is equipped with a powerful and low-noise drive featuring secure positioning achieved by a robust 10 mm motor with planetary gear. By rearranging the variable end stops, a left, right, or 3-way diversion can be selectively created. The electronics are housed compactly within the casing. The diverter can be controlled manually, via buttons/switches or our InduktivCharger, item 8408, enabling digital control capabilities. Like the vehicles, the turnout can be comfortably configured in the CarManager.

currently not available

With filigree latticed brass mast and authentic varnishing. Printed signal arms. Integrated multi protocol digital decoder for DCC/MM provides for an authentic arm movement. Slow signal movement due to special underfloor drive unit. Even authentic single bouncing is individually adjustable. In its delivery status, the bouncing is already adjusted. The compact overfloor drive is includes a decoder placed on the signal mast base. Maintenance free by LED lighting. Suitable for analogue and digital use. Configurable switching outputs can switch relays, e. g. for train control. Feedback via RailCom. For train control it is important to use a relay, due to the low maximum load of the contacts and the short pulse length, e. g. the electronic relay item 5552. With powerful low noise drive. Signal aspects Hp0 und Hp1. Height: 10,3 cm. Drive unit: L 3,5 x W 1,6 x H 0,45 cm.

available

The permanent magnet holder is the ideal solution for testing the CarMotion system. Equipped with one or more magnets, the holder can be flexibly positioned to the right of the roadway. This allows you to precisely verify whether – and at which point – the CarMotion vehicle detects and executes defined control commands. Its sturdy design enables quick setup and easy repositioning during test runs, ensuring accurate results under realistic conditions.

available

4 switches providing comfortable switching of lights, signals and other elements using continuous current. It can also be used as a set of two double pole switches, with the use of the included couplings. Contact load: 2 A.

available

Enhance your CarMotion layout with in-vehicle sound effects. The retrofittable sound modules are vehicle-specific, ensuring they are mechanically, visually, and acoustically tailored to each model. These modules reproduce engine sounds for starting and stopping, as well as various driving-related sounds, such as gear changes, brake squeals, and depending on the vehicle type, even reverse warning signals. The horn, and if equipped, a siren, can also be activated. The engine sound volume is adjustable. The selectable and adjustable sounds can be controlled via remote control, DCC command, infrared command, or magnetic sequence. The circuit board of the sound module is easily connected to the vehicle‘s circuit board using a four-pin connector and secured with screws. The previous left-side components, such as the exhaust and air tanks, are replaced with the new components that house the speaker. Please note that vehicles without the four-pin expansion socket cannot be equipped with a sound module.Output power 250 mW, efficiency 81 dBA, frequency range approx. 800 – 10 kHz.Suitable vehicles: 8013, 8021, 8051, 8054, 8055, 8061, 8065, 8071, 8130, 8132, 8133.L 18 x W 8.8 x H 11.4 mm

available

This flashing light simulates in a deceptively real-looking way the function and the motion of a real rotating flashing light. A retrofit for emergency vehicles of all kinds. Maintenance free by LED lighting.

available