41282 Smoke generator large, diameter 4,5 cm

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

To equip thin wires and litz wires to make them pluggable, e. g. in connection with Viessmann plug-in rail item 6049 or the power module with plug-in rail item 5205. By using adapter pins even very thin wires without resistors and diodes can be plugged in. The wires are injected in the adapter pin without soldering.

Kit. L 8.6 x W 7.8 x H 5.5 cm / L 9.5 x W 8.0 x H 5.0 cmLevel of difficulty: 2 (advanced)

Dimensions: L 89,5 x W 2,8 x H 0,6 cm.

In 1996, Mercedes introduced the ACTROS series in different variants. This vehicle is equipped with an M cab. Like all models of the CarMotion series, it comes with the following functions:- Charging and programming connection- Short charging times due to modern lithium polymer batteries- With a full battery and normal operation with waiting times and various speeds a runtime of approx. 4 – 6 hours, and approx. 2 hours at max. speed/full load is possible.- Easy on/off switching via a reed contact under the cab‘s roof with magnetic pointing stick or telescopic magnetic bar, item 8410- Infrared transmitter/receiver for distance control (limited compatibility with other IR systems)- Realistic braking resp. accelerating action and configurable speed due to speed-controlled motor- Free cargo area due to underfloor drive unit- Cabin lighting- Braking and reversing lights- Direction indicators right/left and warning lights controllable- Low beam / high beam light- Roof beacons (depending on type of vehicle)- Clear seethrough driver‘s cab with figure- 5-pole plug-in coupling for the connection of CarMotion trailers or semitrailers- Compatible with existing systems with contact wire or magnetic tape- Control by infrared light (IR), permanent magnets item 8431 in the road, electromagnetic stop coils and remote control item 8402- Even without mechanical guidance a short straight line reverse is possible via steering by the remote controlL 8.2 x W 3.5 x H 3.7 cm

Kit. Not far from St. Moritz, above Lake Sils in the Swiss canton of Engadin, there is the picturesque summer village of Grevasalvas. Here, in an altitude of almost 2000.0 m you will find the lovely mountain houses which are so typical of this region. With the mountain house Palü, the Engadin, which is a true paradise for hikers and nature lovers, becomes a part of your local model railway layout. All kits of the Grevasalvas series can be wonderfully combined to make up a genuine Swiss village. But even when placed detached on the layout, this kit enhances any alpine model railway landscape due to its construction style which is typical of that country.L 16.0 x W 15.0 x H 9.0 cmLevel of difficulty: 2 (advanced)