5099 H0 Construction/Traffic lights, 2 pieces

This turnout is equipped with a powerful and low-noise drive featuring secure positioning achieved by a robust 10 mm motor with planetary gear. By rearranging the variable end stops, a left, right, or 3-way diversion can be selectively created. The electronics are housed compactly within the casing. The diverter can be controlled manually, via buttons/switches or our InduktivCharger, item 8408, enabling digital control capabilities. Like the vehicles, the turnout can be comfortably configured in the CarManager.

currently not available

Signal in standard construction. Finely detailed metal mast. Authentic varnishing. Suitable for all analogue and digital systems. With base socket. Very simple mounting and wiring. With 2 LEDs, maintenance free. Signal pictures Hp0 and Hp1. Suitable control module: item 5221. Height: 7,9 cm.

currently not available

Enhance your CarMotion layout with in-vehicle sound effects. The retrofittable sound modules are vehicle-specific, ensuring they are mechanically, visually, and acoustically tailored to each model. These modules reproduce engine sounds for starting and stopping, as well as various driving-related sounds, such as gear changes, brake squeals, and depending on the vehicle type, even reverse warning signals. The horn, and if equipped, a siren, can also be activated. The engine sound volume is adjustable. The selectable and adjustable sounds can be controlled via remote control, DCC command, infrared command, or magnetic sequence. The circuit board of the sound module is easily connected to the vehicle‘s circuit board using a four-pin connector and secured with screws. The previous left-side components, such as the exhaust and air tanks, are replaced with the new components that house the speaker. Please note that vehicles without the four-pin expansion socket cannot be equipped with a sound module.Output power 250 mW, efficiency 81 dBA, frequency range approx. 800 – 10 kHz.Suitable vehicles: 8002, 8012, 8018, 8135.L 18 x W 8.8 x H 11.4 mm

available

This cable is designed for extending the 6-pin connector of the programming device, item 8401, or the charger, item 8400. Ideal for wiring hard-toreach modules, such as the IR Mini, item 8403.

available

Turnout similar to item 8448, equipped with lateral actuation mechanisms (left, right) for manual operation. Ideal for systems controlled solely through our CarMotion remote control, item 8402, and permanent magnets, item 8431 (without wiring).

currently not available

The practical 12-pin plug-in rail connects up to 12 power consumers – simply by jacks for plugging in the resistors and diodes. Suitable for using with LED-floor interior lighting items 6045 – 6048. No plugs, screw terminals or soldering required. In order to make even very thin cables and litz wires pluggable, we recommend the adapter pins for rails, item 6044. Dimensions: L 3,2 x W 2,1 x H 0,7 cm.

available