4632 H0 Colour light block signal SBB type N

The N-type signaling system was introduced in 1986, gradually replacing the signals of the L-type on the standard gauge network, especially on the SBB and BLS. Each of these signals can serve as a distant signal. The filigree brass mast is produced with photo-etching technique. Authentic varnishing. Suitable for all analogue and digital systems. Maintenance free by LED lighting. Easy mounting and connection with cylinder base socket. Height: 7.7 cm

available

The N-type signaling system was introduced in 1986, gradually replacing the signals of the L-type on the standard gauge network, especially on the SBB and BLS. Each of these signals can serve as a distant signal. The filigree brass mast is produced with photo-etching technique. Authentic varnishing. Suitable for all analogue and digital systems. Maintenance free by LED lighting. Easy mounting and connection with cylinder base socket. Height: 7.7 cm

available

The transformer provides model train accessories, e. g. lamps, signals and turnouts with required low voltage. Suitable for all kinds of model train systems. Integrated overload protection avoids overload and short-circuit breakdown by timeous cut-off of the transformer. Technical data: Input voltage 230 V - output voltage 10 and 16 V~, maximum power 52 VA. Dimensions: L 13 x W 7 x H 5 cm.

available

Each 2 x 12-pole.

available

Coach lighting with maintenance free, power-saving, bright LEDs with integrated multi protocol decoder (Motorola/DCC). Brightness adjustable by CVs and potentiometer. Can be used in any coach of all manufacturers designed to be equipped with lighting. By shortening the circuit board, it can be adapted to various waggon lengths. Integrated flickering protection for constant light even with short interruptions of the voltage supply, additional capacitors/power packs can be connected. Various lighting effects are adjustable, as start-up simulation of track bed inverter or single flickering tubes. The model offers direction depending switching outputs for front- and rear lighting. An additional switching output up to 150 mA capacity completes the functionalities. Power supply by grinder/point unit or conducting couplers items 5048/5071. Suitable for DC, AC or digital power. Due to low-loss switching regulator the coach lighting warms up only a bit. Maximum power input 20 mA. Dimensions: L 25,4 x W 0,8 cm.

available

The speed camera is equipped with control electronics with 2 switching inputs. The vehicle is recognized via the vehicle detector, item 8441 or via reed contacts. Ideally suited for the CarMotion system.Equipped with one red LED.Height: 3.6 cm

available