4406 N Semaphore distant signal, movable disk

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

The practical 12-pin plug-in rail connects up to 12 power consumers – simply by jacks for plugging in the resistors and diodes. Suitable for using with LED-floor interior lighting items 6045 – 6048. No plugs, screw terminals or soldering required. In order to make even very thin cables and litz wires pluggable, we recommend the adapter pins for rails, item 6044. Dimensions: L 3,2 x W 2,1 x H 0,7 cm.

Signal in standard construction. Filigree brass mast and authentic varnishing. With base socket for easy mounting. With 2 LEDs maintenance free. Signal aspects Hp0 and Hp1. Suitable control module: item 5221. Height: 4,4 cm.

2 separate bistable relays, each with 2 contacts. The relays have no time limits but can be used with continuous current. To control colour light signals and semaphore signals, barriers, block- and train change automatic and so on. Control by positive switching impulses resp. by continuous current or AC. Power consumption: 2 x 14 mA. Maximum load for each contact: 2 A.

Handicraft set. Universally applicable LEDs. No soldering of cables is required. Including resistor and diode. Dimensions: L 1,6 mm x W 0,8 mm.

With filigree latticed brass mast and authentic varnishing. Printed signal arms. Powerful low noise drive. Integrated multi protocol digital decoder for DCC/MM. Slow signal movement due to special underfloor drive unit. Even authentic single bouncing is individually adjustable. By factory setting the signal bouncing is adjusted. Compact overfloor drive is only 4,5 mm high and includes a decoder placed on the signal mast base. Maintenance free by LED lighting. Suitable for analogue and digital use. Configurable switching outputs can switch relays, e. g. for train control. Feedback via RailCom. For train control it is important to use a relay, due to the low maximum load of the contacts and the short pulse length, e. g. the electronic relay item 5552. Signal aspects Hp0 and Hp1. Height: 7,2 cm. Drive unit: L 3,5 x W 1,6 x H 0,45 cm.