The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm
The InduktivCharger enables wireless recharging of vehicles through inductive communication. Vehicles come to a halt on the module and automatically position themselves over the charging coil, allowing charging currents to be self-regulated. These modules are particularly suitable for locations with longer dwell times, such as traffic lights or level crossings. Multiple modules can be interconnected to autonomously guide vehicles to charging positions with upcoming software updates. A control output for the motorized 2/3-way turnout, item 8448, which can also control servos, complements the capabilities. For trucks, the ratio of driving time to charging time is approximately 3 to 1, allowing for virtually unlimited driving time. The InduktivCharger can also switch vehicles with receiver coils on and off. Vehicles need to be retrofitted with the receiver coil, item 8440.Diameter charging coil: 40 mm, diameter electronics: 30 mm, height: 60 mm
Kit. Not far from St. Moritz, above Lake Sils in the Swiss canton of Engadin, there is the picturesque summer village of Grevasalvas. Here, in an altitude of almost 2000.0 m you will find the lovely mountain houses which are so typical of this region. With the mountain house Palü, the Engadin, which is a true paradise for hikers and nature lovers, becomes a part of your local model railway layout. All kits of the Grevasalvas series can be wonderfully combined to make up a genuine Swiss village. But even when placed detached on the layout, this kit enhances any alpine model railway landscape due to its construction style which is typical of that country.L 16.0 x W 13.0 x H 10.0 cmLevel of difficulty: 2 (advanced)
Ideal item to use with our light boxes of house lighting starter set, item 6005 to illuminate each single room or with light rails, item 6045 for floor interior lighting. One LED each, fastened to a small board, provides suitable brightness.