8030 H0 MB ACTROS 3-axle articulate truck, basic, functional model

The semitrailer with rear lighting is equipped with a 5-pole plug-in coupling for the connection to the respective vehicle. By connecting to the tractor, the following functions are transferred to the trailer:• Infrared transmitter for distance control• Braking and reversing lights• Direction indicators right/left and warning lights controllableL 8.5 x W 2.9 x H 4.2 cm

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

The trailer with rear lighting is equipped with a 5-pole plug-in coupling for the connection to the respective vehicle. By connecting to the tractor, the following functions are transferred to the trailer:• Infrared transmitter for distance control• Braking and reversing lights• Direction indicators right/left and warning lights controllableL 8.2 x W 2.9 x H 3.2 - 6.4 cm

Fits perfectly with items 8011 and 8030 MB ACTROS 3-axle articulate truck. The semitrailer with rear lighting is equipped with a 5-pole plug-in coupling for the connection to the respective vehicle. By connecting to the tractor, the following functions are transferred to the trailer:• Infrared transmitter for distance control• Braking and reversing lights• Direction indicators right/left and warning lights controllableL 9.8 x W 2.8 x H 3.8 - 8.6 cm

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

Front axle fully assembled with steering arm and magnet for CarMotion trucks.L 1.5 x W 2.8 x H 1.3 cm