8420 H0 Bumper with LED lighting for trailers and short semitrailers
€21.95*
Delivery time: 2-4 Werktage
available
Article no.: 8420
weee DE86057721
Product information "H0 Bumper with LED lighting for trailers and short semitrailers"
With this set you can retrofit your trailers and short semitrailers of kibri and other manufacturers to be able to use the full scope of functions of the CarMotion vehicles.
Contents: 1 bumper with 5-pole connection plug and infrared transmitter for distance control.
Contents: 1 bumper with 5-pole connection plug and infrared transmitter for distance control.
Login
Customers also bought
8440 Receiver coil for retrofitting CarMotion trucks and buses, inductive charging
€9.95*
The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm
Delivery time on request
8408 InduktivCharger
€129.95*
The InduktivCharger enables wireless recharging of vehicles through inductive communication. Vehicles come to a halt on the module and automatically position themselves over the charging coil, allowing charging currents to be self-regulated. These modules are particularly suitable for locations with longer dwell times, such as traffic lights or level crossings. Multiple modules can be interconnected to autonomously guide vehicles to charging positions. A control output for the motorized 2/3-way turnout, item 8448, which can also control servos, complements the capabilities. For trucks, the ratio of driving time to charging time is approximately 3 to 1, allowing for virtually unlimited driving time. The InduktivCharger can also switch vehicles with receiver coils on and off. Vehicles need to be retrofitted with the receiver coil, item 8440.Diameter charging coil: 40 mm, diameter electronics: 30 mm, height: 60 mm
Delivery time on request
8030 H0 MB ACTROS 3-axle articulate truck, basic, functional model
€199.95*
In 1996, Mercedes introduced the ACTROS series in different variants. This vehicle is equipped with an M cab. Like all models of the CarMotion series, it comes with the following functions:- Charging and programming connection- Short charging times due to modern lithium polymer batteries- With a full battery and normal operation with waiting times and various speeds a runtime of approx. 4 – 6 hours, and approx. 2 hours at max. speed/full load is possible.- Easy on/off switching via a reed contact under the cab‘s roof with magnetic pointing stick or telescopic magnetic bar, item 8410- Infrared transmitter/receiver for distance control (limited compatibility with other IR systems)- Realistic braking resp. accelerating action and configurable speed due to speed-controlled motor- Free cargo area due to underfloor drive unit- Cabin lighting- Braking and reversing lights- Direction indicators right/left and warning lights controllable- Low beam / high beam light- Roof beacons (depending on type of vehicle)- Clear seethrough driver‘s cab with figure- 5-pole plug-in coupling for the connection of CarMotion trailers or semitrailers- Compatible with existing systems with contact wire or magnetic tape- Control by infrared light (IR), permanent magnets item 8431 in the road, electromagnetic stop coils and remote control item 8402- Even without mechanical guidance a short straight line reverse is possible via steering by the remote controlL 8.2 x W 3.5 x H 3.7 cm
available
8090 H0 VW Beetle Type 11, 1302, basic, functional model
€249.95*
Prototype: The VW Beetle Type 11, Version 1302, was manufactured from 1970 to 1972. Equipped with a 1600cc four-cylinder boxer engine, it boasted 50 HP. This model introduced a more modern front axle with MacPherson struts and an independent rear suspension with trailing arms. In 1972, the Beetle surpassed the Ford Model T as the world’s most produced car. Model: The CarMotion variant of this series is prepared for the InduktivCharger, item 8408 and features an integrated receiver coil for wireless charging. Approximately 45 – 60 minutes of runtime under normal driving conditions, up to 30 minutes at maximum speed.It offers: • Charging and programming socket • Fast charging times facilitated by advanced Li-Po batteries • Approximately 45-60 minutes of runtime under normal driving conditions, up to 30 minutes at maximum speed • Easy on/off operation with a reed contact located under the roof • Infrared transmitter/receiver for distance control • Realistic braking and acceleration manoeuvres • Interior lighting, brake lights, turn signals, low/high beams • Visible interior with a driver figure • Compatibility with guide wire, magnetic tape, and infrared control • Inductive charging without the need for additional track aids.L 4.8 x W 1.9 x H 1.7 cm
Delivery time on request
8427 Universal electronics for trucks
€99.95*
The Universal Electronics Truck provides a compact solution for retrofitting vehicles with the proven driving characteristics of CarMotion trucks. The slim module (approx. W 12 x L 26 mm) is particularly suitable for confined installation situations and operates in conjunction with the H0 gear unit with motor, item 8426. Power is supplied through two 60 mAh batteries included in the set. The module is exclusively designed for use with this motor and batteries. An additional distribution board (approx. W 20 x L 7 mm) facilitates the connection of LEDs for lighting tasks and enables additional light effects. An expansion interface for additional modules is available. Included in the set: Reed contact, Hall sensor, charging and programming socket, 2 batteries, rear bumper with lights, IR transmitter, and a trailer connection. The lighting includes LEDs for the driver’s cabin (1 x white), front headlights (2 x white), turn signals (4 x yellow), and 2 IR receivers. All LEDs and sensors are pre-wired to ensure easy installation. Supplementary sets for additional lighting effects are also available.
Delivery time on request
8426 H0 Gear unit with motor
€37.95*
High-performance, low-wear motor for underfloor drive with encapsulated gear and one driven axle, suitable for CarMotion vehicles. The rear axle is non-driven and height-adjustable.Operating voltage: 7 – 12 V DCL 4 x W 2.8 x H 1.3 cm
available