8428 H0 Weights for MB ACTROS vehicles, 3 pieces

Front axle fully assembled with steering arm and magnet for CarMotion trucks.L 1.5 x W 2.8 x H 1.3 cm

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

Coach lighting with maintenance free, bright LEDs. Brightness adjustable by potentiometer. Can be used in any lighting prepared coaches of all manufacturers. By shortening the circuit board, it can be adapted to various waggon lengths. Constant power supply integrated, prepared for flicker-protection. Power supply by grinder / point unit or conducting couplers items 5048/5071. Suitable for DC, AC or digital power. Maximum power input 38 mA. Dimensions: L 25,4 x W 0,7 cm.

The trailer with rear lighting is equipped with a 5-pole plug-in coupling for the connection to the respective vehicle. By connecting to the tractor, the following functions are transferred to the trailer:• Infrared transmitter for distance control• Braking and reversing lights• Direction indicators right/left and warning lights controllableL 8.2 x W 2.9 x H 3.2 - 6.4 cm

The self adhesive magnetic tape is polarized on its surface (south pole on top). It leads the guiding magnets of the CarMotion vehicles. Depending on the type of road, it is integrated into a prefabricated road system or built into the layout plate with the help of a surface milling machine.W 0.3 x H 0.05 cm