5101 H0 2R Connector, fitting to 5100

To reduce the voltage on slow speed sections, e. g. narrowed curves, on building sites or down grades. Integrated 5 watt high power resistors. The value of the resistor is selectable by assignment of the connection socket from 10 – 30 ohm. Short circuit protection included by a temperature dependant switch. An overload short circuit is shown by red LED. On digital layouts only useable with unregulated locomotive decoders.

The wall plates from the stone art series consist of weather resistant sediment composite. This material creates an unmatched realistic stone surface. Due to the two-coloured design, the gaps are pointed out optically. The plates are flexible and can be easily cut with a utility knife.

Prototypical brass mast with base socket for easy mounting. Maintenance free by LED lighting. Height: 7,4 cm.

Kit. L 8.9 x W 2.0 x H 8.3 cmLevel of difficulty: 2 (advanced)

The module allows the transmission of a variety of commands to CarMotion vehicles via infrared signals. These commands range from simple blinking to deceleration and stopping of CarMotion vehicles, for example in front of traffic lights. The two infrared transmitter diodes can be inconspicuously positioned alongside the road or placed horizontally in a small cut-out in the roadway or roadside. Like the vehicles, the module can be conveniently configured in the CarManager. All macros stored in the vehicles can be invoked by the module, including those that cannot be accessed through magnetic sequences for technical reasons. The two IR LEDs transmit different signals depending on the selected operating mode. One of the numerous applications is precise stopping in front of a traffic light or similar. The first IR LED is positioned some distance before the traffic light and sends the command for gradual deceleration when the traffic light is red. The vehicle then gently comes to a stop on an optional stop magnet (north pole). The second IR LED is located in close proximity to the traffic light and sends the start command when the light is green. The module is directly controlled by the Viessmann traffic light controller, items 5094 or 5095, or the level crossing items 5104 and 510) via the control input. The input also allows control of the module through a switch, relay contact, or DCC switch command using a suitable central control unit. Simple commands can also be generated by turning the module on and off, for example, to send blink commands only when a corresponding turnout is set.Board dimensions with cable outlet: ca. L 45 x W 5 x H 5 mmRecommended installation space (programming plug): ca. L 55 x W 5 x H 5 mmCable length to the IR LEDs: each ca. 300 mmIR LED dimensions: ca. L 2 x W 1.2 x H 1.2 mm

Signal in standard construction with base socket for easy mounting. With each 2 red and white LEDs, maintenance free. Signal pictures Sh0 and Sh1. Suitable control module: item 5221. Height: 0,8 cm.