Product added to compare
Product information "Motion drive for signals "
With a slow motion drive as well as a freely useable closing contact up to 2 A. The control of the drive is followed by an impulse of 16 V. Due to the built-in switch impulses DC operation is possible, too. Current consumption at the point of switching is 0,7 A. Technical data: Operating displacement: 0,5 cm, actuation wire: 9 cm, actuation power: 0,1 N (ca. 10 g), actuation speed: approx. 1 cm/s. Dimensions drive unit: Ø 1,3 cm, L 6,79 cm, cover plate: L 1,5 x W 1,5 cm.

0 of 0 reviews

Leave a review!

Share your experiences with other customers.


Customers also bought

6046 LED for floor interior lighting warm-white, 10 pieces
Ideal for use with the floor interior lighting item 6045. The LEDs can be precisely glued into the racks for individual illuminating of entire floors or individual single windows in buildings of all kinds. Each one LED provides the right brightness. Also available as item 6047 yellow and item 6048 white LED. Same for light boxes of house illumination starter set item 6005.

€17.50*
available
Stk
5547 Push-button panel 2-aspect
With impulse contact for 4 turnouts resp. for 2-aspect semaphore signals or up to 8 uncoupling tracks. Especially suitable for the hobby colour light block signal item 4021, signal module item 5210, electronic relay item 5552 as well as control module for light block signals item 5221. In analogue mode controls the panel the control module for light signals items 5224, 5229 and 52292 when 2-aspect signals are connected. Several panels may be connected. Contact rating: Up to 2 A.

€26.95*
available
Stk
6006 House illumination with 1 LED warm-white,10 pieces
Ideal item to use with our light boxes of house lighting starter set, item 6005 to illuminate each single room or with light rails, item 6045 for floor interior lighting. One LED each, fastened to a small board, provides suitable brightness.

€28.50*
available
Stk
5095 H0 Traffic light with pedestrian signal and LEDs, 2 pieces
Traffic lights suitable for epochs III - VI. Each set contains 2 traffic lights, each with a red, yellow and green LED for road traffic and a red and green LED for pedestrians. Suitable for crosswalks as e. g. zebra crossings. Prototypical filigree brass mast with base socket for easy mounting. Maintenance free by LED lighting. Attached electronics controls both traffic lights in an automatic sequence. Height: 6 cm.

€60.50*
available
Stk
3560 LED warm-white with soldered cables, 5 pieces
Handicraft set. Universally applicable LEDs. No soldering of cables is required. Including resistor and diode. Dimensions: L 1,6 mm x W 0,8 mm.

€14.50*
available
Stk
6044 Adapter pin for rails, 25 pieces
To equip thin wires and litz wires to make them pluggable, e. g. in connection with Viessmann plug-in rail item 6049 or the power module with plug-in rail item 5205. By using adapter pins even very thin wires without resistors and diodes can be plugged in. The wires are injected in the adapter pin without soldering.

€3.50*
available
Stk