Skip to main content Skip to search Skip to main navigation

Product information "H0 MB ACTROS with snowplough and spreader "

Kit. Prototype data: MB ACTROS M2640, 6 x 4, V6 engine, 290 kW/394 HP, max. torque at 1080 rpm. MEILLER tipper body, payload approx. 15 t, BEILHACK universal snowplough PVF 40-4 H, clearing width approx. 3 m, snowplough width 3.6 m.
L 11.0 x W 4.0 x H 4.0 cm
Level of difficulty: 2 (advanced)

Warn- und Sicherheitshinweise

Modellbauartikel, kein Spielzeug! Nicht geeignet für Kinder unter 14 Jahren!



Hersteller

Viessmann Modelltechnik GmbH
Bahnhofstr. 2 a
35116 Hatzfeld-Reddighausen
Kontakt

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Customers also bought

Average rating of 0 out of 5 stars

6044 Adapter pin for rails, 25 pieces
To equip thin wires and litz wires to make them pluggable, e. g. in connection with Viessmann plug-in rail item 6049 or the power module with plug-in rail item 5205. By using adapter pins even very thin wires without resistors and diodes can be plugged in. The wires are injected in the adapter pin without soldering.

€3.50*

available

Product Quantity: Enter the desired amount or use the buttons to increase or decrease the quantity.
Stk

Average rating of 0 out of 5 stars

39450 H0 Loco shed, tripple track
Kit. This modern loco shed fits perfectly to epoch III – V. The big glass facades provide best lighting conditions inside, where repair and revision work can be done. The doors can be manually operated. Installation of catenary system inside is possible. The engine shed can be extended with another kit item 39450. Not suitable for track beds (except Fleischmann).L 34.5 x W 20.0 x H 11.5 cm / Passage height 8.5 cm / Passage width 3.7 cm / Track middle radius 5.75 cmLevel of difficulty: 2 (advanced)

€56.50*

currently not available

Average rating of 0 out of 5 stars

38605 H0 Mesh wire fence, grey
Kit. L 280.0 x W 0.2 x H 2.5 cmLevel of difficulty: 1 (beginners)

Content: 2.8 m (€7.48* / 1 m)

€20.95*

available

Product Quantity: Enter the desired amount or use the buttons to increase or decrease the quantity.
Stk

Average rating of 0 out of 5 stars

8440 Receiver coil for retrofitting CarMotion trucks and buses, inductive charging
The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

€9.95*

available

Product Quantity: Enter the desired amount or use the buttons to increase or decrease the quantity.
Stk

Average rating of 0 out of 5 stars

5552 Electronic relay 2 x 2UM
2 separate bistable relays, each with 2 contacts. The relays have no time limits but can be used with continuous current. To control colour light signals and semaphore signals, barriers, block- and train change automatic and so on. Control by positive switching impulses resp. by continuous current or AC. Power consumption: 2 x 14 mA. Maximum load for each contact: 2 A.

€37.95*

available

Product Quantity: Enter the desired amount or use the buttons to increase or decrease the quantity.
Stk

Average rating of 0 out of 5 stars

38629 H0 Pavement
Kit. Paving stone L ca. 249.6 x W 2.0 x H 0.1 cmAsphalt L ca. 166.4 x W 2.0 x H 0.1 cmLevel of difficulty: 1 (beginners)

€15.95*

available

Product Quantity: Enter the desired amount or use the buttons to increase or decrease the quantity.
Stk