7163 Z Lattice mast light, 2 LEDs white

Signal in standard construction. Finely detailed metal mast. Authentic varnishing. Suitable for all analogue and digital systems. With base socket. Very simple mounting and wiring. With 2 LEDs, maintenance free. Signal pictures Hp0 and Hp1. Suitable control module: item 5221. Height: 7,9 cm.

currently not available

The receiver coil enhances vehicles with inductive charging capabilities and necessary communication. It effortlessly clips onto the transmission block and is connected to the vehicle board through a two-pole plug connection. When used in conjunction with the InduktivCharger, item 8408, it enables unlimited runtime without user intervention. Vehicles can be powered on and off at inductive charging stations. The runtime-to-charging-time ratio is approximately 3:1, depending on system and vehicle conditions. Suitable for all CarMotion system vehicles without built-in receiver coils.Outer dimensions: L 2.4 x W 1.3 x H 0.27 cm

available

This special point machine is a powerful, silent drive with its respective digital decoder for installation in Märklin and Trix C road bed points. The decoder is located in the cable making the drive particularly compact. The point machine stands out for the prototypical slow movement of the point blades. Speed and motion are controlled electronically and ensure a sensitive drive. If – due to the characteristics of your turnout – the direction of the turnout does not fit with the switching direction of the command station, it is possible to set the point motor to reverse mode. The associated decoder is suitable for DC/AC, MM and DCC and is able to send the requested position or the actual position by RailCom to corresponding digital command stations (e. g. Viessmann Commander item 5300/5320). Analogue mode is possible. Additional switching outputs for relays or LEDs and for a conventional feedback and frog polarisation complete the functions of the point machine. Their function is configurable.Märklin C turnouts:24611 left hand turnout24612 right hand turnout24624 double slip switch DKW24630 three way turnout (2.pieces drives)20671 left curved turnout with manual hand lever20672 right curved turnout with manual hand lever24671 left curved turnout24672 right curved turnout24711 left hand wide radius turnout24712 right hand wide radius turnout24771 curved turnout left24772 curved turnout rightTrix C turnouts:62611 C track left hand turnout62612 C track right hand turnout62624 C track double slip switch 62671 C track left curved turnout62672 C track right curved turnout62711 left hand wide radius turnout62712 right hand wide radius turnout62771 curved turnout left62772 curved turnout right

currently not available

These couplers allow you to provide an easy power supply system for the entire train. The couplers are equipped completely with 2 connection cables and fit into the standard NEM 362 coupling shaft. The couplers are contact-proof and cannot be uncoupled automatically, yet easy to separate and to couple. The thin cables (0.6 mm) allow a very easy mounting. Current consumption: max. 750 mA.Contents: 3 pairs with 3 adapters each (S: norm, M: +0.3 mm and L: +0.6 mm).

available

Ideal for use with the floor interior lighting item 6045. The LEDs can be precisely glued into the racks for individual illuminating of entire floors or individual single windows in buildings of all kinds. Each one LED provides the right brightness. Also available as item 6047 yellow and item 6048 white LED. Same for light boxes of house illumination starter set item 6005.

available

To equip thin wires and litz wires to make them pluggable, e. g. in connection with Viessmann plug-in rail item 6049 or the power module with plug-in rail item 5205. By using adapter pins even very thin wires without resistors and diodes can be plugged in. The wires are injected in the adapter pin without soldering.

available