Controlling Module 5223 with Roco z21

  • Hello,
    I am using the signal 5013 with the control module 5223. Using the decoder 5212 I am trying to control it with the Roco z21 without success. I would like to inform me about the right configuration of the addresses in order to operate all the signals. I am using the addresses 27, 28and I have connected the wires exactly like the manual.


    Thank You

    • Offizieller Beitrag

    Hello,


    please proceed according to the instruction manual of the decoder 5212. This must be able to read on a shift position during programming. You must call a keyboard-side at the command station, where the decoder can read the address assignment and then also where the signal module is connected and will be switched. Unfortunately we can not give it a try, because a Z21 is missing.

    Mit freundlichen Grüßen
    Wolfgang Brinken
    Viessmann Modelltechnik GmbH