Please I want to update my commander from version 1.015 but I am unable to install the drivers from the DVD, I am using Win XP, but when It looks for the drivers on the DVD they cannot be found, please is there any way I can do this, or can I download the driver from somewhere?
Many Thanks
Paul..
Installing USB Drivers?
-
-
Hi Paul!
Please look there...
http://www.viessmann-commander.de/Seiten/Software-Update.htm
Best Regards
Rick -
Hello.. thanks I did look there but could not see them..
Paul.. -
Hi Paul,
try to use this one...For the driver:
http://www.viessmann-commander…Treiber%20Version%202.exeFor the last update:
1) 1.18
http://www.viessmann-commander…CommanderUpdateV1_018.exe2) 1.021
http://www.viessmann-commander…CommanderUpdateV1_021.exeFirst you must install the version 1.018 and then 1.021!!!
Rick
-
Thank you for the information, I tried updating the 1_018.exe but right at the end I got the Microsoft error reporting message that there was a fault with the commander download, so I then tried the 1_021.exe and that all went ok, and when I rebooted the commander it now says I have version 1_021.. but how can I find out if I have the updates in 1_018 which I think I did not get???
Paul..
-
Hello Paul,
the version 1.018 runs imidiately after the intro into the update modus. So if you still would have installed this version you cannot work with the Commander. The version 1.021 starts and runs into the normal operation mode. So I am sure you have installed the version 1.021.
-
Thank You.. yes I installed the 1_021.exe OK, but I am not sure if I have the 1.018 download because it crashed, Do you know if there a way of checking to see if I have any of the updates included in 1.018?
Thanks
Paul.. -
Hi Paul,
if the Commander is working, all is correct. The version 1.021 could not load
without 1.018 before. If you see 1.021 the update is complete.Regards
Rick -
Ahh!! Wonderful.. thank you.
Paul..