I built a passing corner siding with a 24995 control track connected to a Marklin S88 device.
On inputs of s 88 is 1-2 and 5-6 connected two turnout switch pairs.
If I put two trains #72 and #78 on each siding I want to press GREEN button on input 1 or 5 to select which train runs.
Both trains pass over common #18 control track.
Two turnouts are Sw-1 and sw-2 for enter and exit of inside and outside sidings.
Straight goes to outside siding.
So when I press #1 GREEN and
(+ in diagram) sw-1 and sw-2 switch to inside siding.
Train #78 starts at half speed.
Siding should turn YELLOW until train passes #18 sensor(# in diagram).
When it passes over #18 it slows and light goes on.
When I press #2 red it stops and turns off light.
The next route will do same with outside #72 only if #78 is RED.
I can't get the activate and sense in route editor to work.
Also can't get START KEY and DESTINATION to do any input from diagram.
I want to be at ROUTE MONITOR Fully Automatic and start with #1 GREEN.
Any one help with English step by step from factory reset !