I have found the following problems which I hope a user can help me with or they may be examples of bugs in the software that should fixed in a future update.
1. Using routes containing a number of points/turnouts I find that when they are operated the point/turnouts are set correctly but not all of the track symbols are changed to correspond with the route setting. This occurs in manual and automatic modes. Operating each point/turnout individually is normal with the track and the symbol matching correctly. What am I doing wrong or is this a bug in the software?
2. If you alter your layout and move a feedback track symbol it contues to show the operation in it's previous position and the new position at the same time if you are using the grey track symbols. If you overwite the previous feedback position with black track symbols this cures the problem. Again is this a bug in the software?
3. Many model railway layouts have the situation where you have twin parallel tracks connected by two point/turnouts operated by a single accessory decoder. You need two point/turnout symbols with the same address to manage this. The practice will not work currently with the software. The only way I have found to overcome this is to allocate a second address with a false or dummy value so in setting routes the symbols have the potential to be set correctly.
Can this be changed in a future update to the software to allow two point/turnout symbols to have the same address?
Looking forward to a reply.