Control module 5223 and accessorry decoder 5212 how to wire?

  • Gentlemen,


    Hopefully someone can help me. I have a control module 5223 and accessorry decoder 5212 wired according to the operating instructions of the control module. So far so good. Then i pushed the button on the 5212 one time and the 5223 starts to switch internally. Then i try to connect to my Ecos but no reaction. I have tried this for several times, i use the 5212 also for my turnouts and no problems, i have changed the 5212 for another one in case of malfunction, still no reaction. Perhaps i made a mistake so i am human.
    Can someone help me?


    Gr Frank Boeree

  • Hi Frank


    Do you really mean the ECOS?


    John

    Commander with S88 Littfinski feedback for track monitoring and reed switches.


    5 amp booster connected to the CDE port.


    Lenz LI-USB interface connecting to a laptop via the LSB bus using RocRail software to drive trains manually via an Android phone.

  • Hello John,


    Yes, i mean the EcoS 1.
    Normally i have never problems with any kind of decoder. Esu, LDT, Viessmann or Lenz doesn't matter.
    I was forgotten to mention that i didn't short circuit the 5212 as in te picture the 5211 is.


    Gr. Frank

  • Hallo Frank,


    please ask in ECOS forum too.

    Viel Grüße
    Dieter Riethenauer


    Commander 1.402, seit 12.07, Fleischm.profigleise N
    Viessmann u. Uhlenbrock Schalt/Magnetartikeldekoder
    Rocco RM 10787 am LSB hinter Viessmann BM 5206,
    Viessmann Booster ECO4, Win 10- 64bit