Hello
I hope that everyone is staying healthy!
I have a problem with the Conductor command in multiple sequential routes operating at the same time.
I have 2 sequential routes:
Route #1: this route has 4 sequential routes, the first route is set to ‘Semi Auto’ and the following three routes are “manual” and controlled by conductor commands in each card7.
Route #2: this route has 3 sequential routes, the first route is set to ‘Semi auto’ and the following two routes are “manual” and controlled by conductor commands in each card 7.
If I operate either of these two routes (#1 and #2) separately, they function OK.
However, if I allow them to operate at the same time, Route #2 always fails at the Conductor command between the 2nd and third route in the sequence. The 3 rd route does not activate.
Do you have a suggestion?
Best Regards,
Don