Hello.
I have 5 RM contacts and made simply test shuttle scheme at straight lined up track with 2 ends.
So that:
1 route - forvard motion.
2 route - backwards.
I program it and prepared placements of locos at manual mode and run it at fully authomated mode.
All works OK except CANCELLATION of routes option:
In case of cancellation route N1 ( at route N2 - this option also dont works) i placed some commands:
1) LocoIDStop
2) Lock Route 1 for 1 min (or i tried to:) 3) Locl Route 2 for 1 min
4) Shut off the light.
Route 2 also added to cross matrix.
When train reaches the end contact - It IMMEDIATELY shut off the lights and immediately starts COMING BACK (goes to next route without waiting, as i would wish )
If i dont place duplicating stop command LocoIDStop at switching page - the single Stop command at cancellation option is not proceed (on the contrary - light shut off command - always proceed) and train continue running over the end of scheme.
QUESTION:
How to REPAIR my route and make them workable?
I mean:
- working of stop command at cancellation.
- working of waiting(locking route) command at cancelation.
EXPLANATION OF MY WISHES:
I have no free entries at "ON THE WAY" page to insert this commands.
Therefore i must entry it only in cancellation page.
By the way, please add more entries at ON THE WAY page! (there are only 3 contact-associated commands, and no more at V052)
It would need to proceed different speed stages as speed restriction along long routes as well as it needs to shut on the light at tunnels - which are associated to other RM contacts.
------
Thanks,
Vadim
