Hi Dieter ,
I have a digital switch DR4018 that I would be user for the driving changes .
Now he is not working properly , I think that I have to reset the DR 4018 (http://www.digikeijs.com/dr401…annel-switch-decoder.html)
the instruction is:
Reset the module to factory settings using POM programming
Use this method to reset the module to factory settings using POM programming .
Step 1 : Connect the signal input on the decoder output to the rails on your control unit . Step 2 : Ensure the module is receiving power from the module 's power input . ( You can usefull connect the power and signal inputs to eachother )
Step 3 : Set your control unit to POM programming mode . ( You can find more information about the POM mode in your control unit 's manual )
Step 5 : Choose local address on your 9999 control unit .
Step 6: Press the button on the module until the LED goes on .
Step 7 : Then programmable decimal value 8 in CV8 .
Step 8: Press the button on the module until the LED goes out .
Step 9 : It is important when carrying out a RESET That the module is now disconnected from the power . Disconnect both the power and the signal inputs and wait for 3 to 5 seconds .
Step 10: The decoder can now be reconnected to the power and will have returned to the factory settings . BE CAREFUL ! The decoder has now address one again .
Can you tell me:
how I can run ? Step 3
Step 7 should I do in tab 6 is that correct?